FT-5 User Manual Page 50
2.
Place the MKS board next to the power supply
and secure it in place using four M3x12mm
screws and four M3 Nylocks.
Note: The power supply and the MKS board
should be mounted facing each other.
3.
Place FT19 onto the base plate, line up the slots
with the tabs. Slide a M3 square nut into the
slot and screw a M3x16mm screw in. It should
look like the picture to the right with the base
at the bottom and electronics facing the rear of
the printer.
4.
Place FT21 onto the left side, as viewing from
the rear of the machine, and secure it in place
using two M3x16mm screws and two M3
square nuts.
5.
Place the power outlet onto FT20 and secure it
in place using two M3x16mm screws and two
M3 Nylocks.
