10
ASSEMBLY INSTRUCTIONS (Continued)
INSTALL THE OPTIONAL
CARRIAGE BELLOWS (if ordered)
Optional carriage bellows are available to keep excess
grindings, dirt, etc. out of the carriage assembly. To
install the two bellows:
1. Remove the left and right outside leg panels.
2. Remove the shaft seal on each side of the linear
actuator. See FIG. 9. NOTE: When the bellows are
used, the shafts don't get lubricated and the seals
would run dry. They would then become noisy and
not operate properly.
To remove the seals:
a. Crank the carriage all the way toward the
front (that is, toward the operator's position).
b. Remove the actuator mounting screw on top
of the carriage. See FIG. 9. Then push the
carriage toward the right end of the Grinder.
c.
Loosen the two set screws in the bearing
pillow block at each end of the drive shaft.
Loosen the two set screws in the drive
coupling at the right end of the carriage.
d. Turn the actuator release lever clockwise 1/2
turn until the actuator is released from the
shaft. See FIG. 9.
e. Slide the drive shaft out the left end of the
machine.
f.
Remove the shaft seals from the actuator -
two screws each.
g. Reinstall the drive shaft. The right end of
the shaft (inside the coupling) should be
1/8 - 1/4" [3 to 6.5 mm] from the end of the
motor shaft. Retighten all set screws.
h. Push the carriage back to the left, and
reattach the actuator with the mounting
screw. See FIG. 9. Turn the actuator
release lever, 1/2 turn.
3. Remove the two rail wiper brackets from each side
of the carriage - two screws each. See FIG. 11.
4. Attach the outer end of each bellows to the Grinder
leg panel. See FIG. 10. Use six bolts, and hex
nuts, at each end. The bolt heads go on the bellows
side of the brackets.
5. Attach the inner end of each bellows to the carriage.
See FIG. 11. Use four L-brackets, (two on each
side of the last bellows fold), six bolts, and two hex
nuts at each end. Nuts are required only for the
lower holes of the L-brackets.
6. Press the bellows down until it snaps onto the
carriage rails.
7. Reattach the left and right outside leg panels.
FIG. 9
Actuator Mounting
Screw (under the rubber
splash guard)
Drive Shaft
Actuator Bar Assembly
Linear Actuator
Seal Plate
Actuator Release Lever
Summary of Contents for ACCU-Pro 670
