SETTING THE TIMER
It is possible to set up TIME ON and TIME OFF times for the system.
Press the
PAGE key on the keypad to select Page 3.
Press the
TIM ON key to increase the TIME ON setting (left-hand column) in 5-minute increments from 5
to 30 minutes.
Press the
TIM OFF key to increase the TIME OFF setting (left-hand column) in 5-minute increments
from 5 to 30 minutes.
After setting the TIM ON and TIM OFF, the timer can be activated by pushing the
TIMER key.
While the machine is operating, the value in the right-hand column for the TIM.ON decreases starting from
the maximum value shown on the left until 0 is reached. Identical procedure is valid for the pause time.
SETTING THE PUMP FUNCTION
Use the
key on the keypad to toggle between the 3 pages
Check the settings on Page 1. SYS should be MAN and all EV should be set to 0;
Check the settings on Page 2. PMP should be OFF and Radio should be OFF
Check the settings on Page 3. TIM should be OFF
Press the
PUMP key to switch between OFF, AUT, and MAN
When the PMP is set to OFF, it will be deactivated.
When the PMP is set to AUT, it will start automatically whenever the fan is activated and will continue to run
until the fan operation is terminated.
When the PMP is set to MAN, it will start immediately and run until the PMP is set to OFF.
NOTE: The Electric Valves will NOT be automatically activated whenever the pump is running. They must
be turned on seperately by pressing the appropriate EV key on the keypad. The electric valves will NOT be
deactivated when the pump is turned OFF. They must be turned OFF manually by pressing the appropriate
EV key on the display.
SETTING RADIO CONTROL
Transmitter Button controls:
First Row: Tilt UP and DOWN
Second Row: Oscillate Left and Right
Third Row: Fan ON/OFF and Electric Valve 1 ON/OFF
Fourth Row: Electric Valve 2 ON/OFF and Electric Valve 3 ON/OFF
Fifth Row:Not Used
Sixth Row: ON/SYSTEM AUTO mode and Pump ON/OFF
Use the
PAGE key to toggle between the 3 pages.
Check the settings on Page 1. SYS should be in MAN; and all EV should be set to 1.
Check the settings on Page 2. PMP should be AUTO and Radio should be OFF.
Check the settings on Page 3. TIM should be OFF.
Press the
key on the keypad to select the page 2.
Press the
RADIO key to switch from OFF to ON.
Once the RADIO on the machine control panel is set to ON, only the PAGE and RADIO keys will function.
Insert a fully charged battery into the Radio Transmitter
Pull out the red tab on the top of the Transmitter.
Briefly press the Transmitter ON button (bottom left hand position on the Transmitter)
Then hold the same button down until the LED light begins flashing green.
The transmitter is now ready to use and provides the following functions:
