Foerster CIRCOGRAPH DS, Operating Instructions Manual

Page: 45 / 67

OPERATION 4.3 Adjusting nominal diameter
6.452
37
Fig.4.8 Fitting nozzles exit side, legend see Chapter 2.7
Exit nozzle 5 - 30 mm
NOTE !
The outer sleeve (12.2) is already in place.
Fit the exit nozzle (3) onto the dovetail guide of the inner sleeve(12.1).
Insert the inner sleeve(12.1) with exit nozzle (3) fitted into the outer
sleeve (12.2).
Tighten three Allen screws M 6 x 16 DIN 912 with 6 Nm (E).
Exit nozzle > 30 mm
NOTE !
The outer sleeve (12.2) is not in place.
Fit the exit nozzle (3) into the faceplate by turning it and fit the clamping
ring exit (2).
Tighten four Allen screws M 6 x 20 DIN 912 with 6 Nm (D).
Allen screws (D)
Allen screws (E)