Focus Curvifocus, Installation, Servicing And User Instructions Manual

Page: 14 / 28

14
Position Logs C5, & C6 as shown in the diagram.
Position Log C7 as shown in the diagram.
COMMISSIONING THE APPLIANCE
A. PILOT IGNITION CHECK
1. Ignite the pilot light as described in the User Instructions
2. Check that the pilot flame stays alight
3. Extinguish the pilot light
B. MAIN BURNER CHECK
1. Ignite the pilot light as described in the User Instructions
2. Turn on the main burner as described in the User Instructions
3. Check that the pilot smoothly cross-lights to the main burner and that
the main burner and pilot stay alight
4. Check the operation of the «effect» burners as described in the User
Instructions
5. Extinguish the appliance fully
C. PRESSURE CHECK
The appliance is preset to give the correct heat inputs as listed in the
technical details. No further adjustment is necessary. Always check the
inlet pressure and burner pressure.
1. Turn off the gas valve on the appliance
2. Release the screw on the Inlet Pressure test point on the gas valve and
connect a manometer
3. Check that the measured pressure is as the prescribed supply pressure
4. Perform the test when the appliance is burning on full (inc. «effect»
burners) and with only the pilot alight
5. If the pressure is low, check the gas supply pipes are too a correct sizing
6. If the pressure is too high (more than 5 mbar over) the appliance may be
installed, but the gas supply company should be contacted
7. Release the screw on the Burner Pressure test point on the gas valve
and connect a manometer
8. Check that the measured pressure is as detailed in the Technical details
9. The measured value should be /- 10% of the described value.
If this is not the case, please contact the supplier.
NOTE: After checking the pressures and removing the manometers,
the screws in the Pressure Test points must be closed, and
the system must be checked for gas-tightness
Installation instructions