9.0 OPERATING THE APPLIANCE
7
GB IE
©
20
2
1 Focal Point Fires
Ltd
.
Remote Operation
NOTE:
The heater should be powered on using the ON/OFF switch before it can be operated using remote control.
The remote control requires 2xAAA size batteries (Not included).
Open the battery compartment by sliding the cover down and insert the batteries noting the polarity indicated in the battery compartment.
Keep batteries out of reach of children.
Remote control operations are identical to the functions on the control panel.
The remote control must be point directly at the sensor on control pad.
Switch the appliance ON
Set to standby mode
Go up in the menu
(change day)
Increase temperature
Increase hour/ minute
Set day/time
Set timer key
Go down in the menu
(change day)
Toggle between 5 different
flame brightness levels
Confirm selection
Press to activate low level
heating
Cancel key
Set open window detection
Press to activate high
level heating
Decrease temperature
Decrease hour/ minute
Timer on/off key
2x AAA, 1.5V
Heater powered OFF
Heater powered ON, set to standby mode
Press to switch flame effect ON/ OFF
Press and hold to toggle between 5 different flame settings
1000W
Press to activate the low setting (1000W)
2000W
Press to activate the high setting (2000W
)
Indicator lights
Buttons
Manual Operation
NOTE: The heater only starts working if the set temperature is higher than the ambient room temperature.
Switching ON/OFF
Use the ON/OFF switch to power on the heater (set it to standby mode).
In standby mode, the heater can be operated either manually, by the switches located at the front and right hand side of heater or by the
supplied remote control.
