7.0 INSTALLING THE APPLIANCE - CONTINUED
6
8.0 FITTING THE DECORATIVE FRAME
The appliance may be supplied with a decorative frame in a variety of finishes.
IMPORTANT : Due to the possibility of sharp edges, care should be
taken when handling the frame components. The use of protective
gloves is recommended.
If not pre-fitted, and the appliance is supplied with a one piece decorative frame
that is to be attached to the front of the firebox. The firefront shown in these
instructions may be different to the one supplied with the appliance.
If the frame has a bracket at the top as per Figure 5. Carefully hook the bracket
on the rear of the frame on to the very top of the black firebox. Do not hang
the frame on the “U” shaped stainless steel heat deflector.
THE FRAME MUST NOT COVER ANY OF THE HEATER OUTLET!
Next, carefully pull the bottom of the frame out towards you and insert 4x mag-
nets along the bottom edge of the appliance under the glass 75mm in from the
left and right hand edge as shown in Figure 6. Then lower the frame back towards
the firebox where the magnets will make a connection.
To remove the frame, pull the bottom of the frame away from the fire to break
the magnetic connection, remove the magnets, then gently lower the frame back
towards the firebox. Lift the frame up and away from the wall to remove the
frame from the engine.
Alternative fixing method
Attach the front frame by carefully positioning it onto the heater engine, align-
ing the slots on the brackets at either side of the heater engine. Check that the
fan outlet, mounted at the top of the appliance, is not covered or obstructed in
any way. Ensure the power to the fire is switched ON.
GB IE
©
20
2
1 Focal Point Fires
Ltd
.
Fixing the appliance
Do not connect the appliance until the instructions are read carefully and the
heater properly and securely installation.
Caution: Do not lift the heater using the front frame.
Remove the front frame by lifting it up and away from the heater engine.
Offer the appliance into the opening to ensure a good fit, once in the final posi-
tion mark the positions on the wall through the 4x fixing holes.
Drill the wall as appropriate for the type of wall as previously described in this
section, and insert the chosen type of wall fixings.
DO NOT REMOVE THE FEET FROM THE BOTTOM OF THE APPLIANCE!
IF FITTING WITH OUT A LEVEL SURFACE/ SHELF ENSURE A 8MM GAP IS
PRESENT UNDER THE BOTTOM EDGE OF THE APPLIANCE.
Insert the wall fixing screw through the fixing hole in the bracket on the fire-
box, then screw into the wall plug.
Then repeat on the opposite side and the 2x lower fixing brackets.
Fixing hole
Slot
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
4x Magnets
each side
DO NOT BLOCK THE
HEATER INLET OR
OUTLET
