background image

©

2019 Focal Point Fires plc.

I N S TA L L AT I O N   &   U S E R   I N S T RU C T I O N S

2

GB IE

Section

Contents

Page No.

1.0

Important Notes

2

2.0

Installation Requirements

3

3.0

Appliance Data

3

4.0

Component Checklist

4

5.0

Site Requirements

4

6.0

Clearances To Combustibles

5

7.0 

Unpacking The Appliance

5

8.0

Installation Wall Mounted

5

Section

Contents

Page No.

9.0

Operating the Appliance

8

10.0

Safety Cutout System

11

11.0

Cleaning and Maintenance

11

12.0

Troubleshooting Guide

12

13.0

Servicing

12

14.0

Appliance Dimensions

13

15.0

Guarantee - Terms and Conditions 13

1.0 IMPORTANT NOTES

IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

   

When using this electrical appliance, basic precautions should be followed to reduce the risk

of fire, electric shock and injury to person, including the following:

• This heater must be used on an AC supply only and the voltage marked on the heater’s

rating label must correspond to the supply voltage.

• DO NOT switch the appliance on until it is properly installed as described in this

manual.

• This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if they

have been given supervision or instruction concerning use of the appliance in a safe way and

understand the hazards involved. Children shall not play with the appliance. Cleaning and

user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.

Children aged from 3 years and less than 8 years shall only switch on/off the appliance

provided that it has been placed or installed in its intended normal operating position and

they have been given supervision or instruction concerning use of the appliance in a safe

way and understand the hazards involved. Children aged from 3 years and less than 8 years

shall not plug in, regulate and clean the appliance or perform user maintenance.

• CAUTION: Some parts of this product can become very hot and cause burns.

Particular attention has to be given where children and vulnerable people are present.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualified persons in order to avoid a hazard.

• The heater must not be located immediately below a socket-outlet.

• DO NOT use this heater in the immediate surroundings of a bath, a shower or a

swimming pool.

• WARNING: In order to avoid overheating, do not cover the heater.

• DO NOT use this heater with a programmer, timer, separate remote-control system or

any other device that switches the heater on automatically, since a fire risk exists if the

heater is covered or positioned incorrectly. 

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal

cutout, this appliance must not be supplied through an external switching device, such as a

timer, or connected to a circuit that is regularly switched on and off by the utility.

• WARNING: This heater is not equipped with a device to control the room

temperature.Do not use this heater in small rooms when they are occupied by persons not

capable of leaving the room on their own, unless constant supervision is provided.

• Keep furniture, curtains and other fabric material away from the appliance.

• DO NOT leave the appliance unattended during use. 

Summary of Contents for EBONY ELECTRIC














Reviews: