FMS Twin 70mm EDF SU-27 PNP, Instruction Manual

Page: 9 / 47

9
EN
Receiver diagram
Gear
5
Spare
6 6
5
4
3
2
1
1.Pull back on the latch and remove the battery hatch.
2.Apply the hook tape to the cable end of the battery.
3.Slide the full charged battery into the battery compart-
ment wtith the power supply cable toward the rear end of
the plane.
The cables from the servo connector board should be con-
nected to your receiver in the order shown. Note that the
LEDs can be powered by any spare channel on the receiv-
er. Tuck the wire leads into the recessed cavity towards
the rear of the battery hatch.
Note: The center of gravity can be adjusted by moving
the battery forward or aft. Having the correct center of
gravity is critical to achieving proper flight characteristics.
Battery installation
Gear
Spare
Throttle
Rudder
Gear
EIevator
Important ESC and model information
The ESC included with the model has a safe start. If the motor battery is connected to the ESC and the throttle stick is not in
the low throttle or off position, the motor will not start until the throttle stick is moved to the low throttle or off position. Once the
throttle stick is moved to the low throttle or off position, the motor will emit a series of beeps. Several beeps with the same tune
means the ESC has detected the cells of the battery. The count of the beeps equals the cells of the battery. The motor is now
armed and will start when the throttle is moved.
The motor and ESC come pre-connected and the motor rotation should be correct. If for any reason the motor is rotating in the
wrong direction, simply reverse two of the three motor wires to change the direction of rotation.
The motor has an optional brake setting. The ESC comes with brake switched off and we recommend that the model be flown
with the brake off. However, the brake could be accidentally switched on if the motor battery is connected to the ESC while the
throttle stick is set at full throttle. To switch the brake off, move the throttle stick to full throttle and plug in the motor battery. The
motor will beep one time. Move the throttle stick to low throttle or the off position. The motor is ready to run and the brake will
be switched off.
Battery Selection and Installation. We recommend the
22.2V 5000-6000mAh 50C Li-Po battery. If using another battery, the
battery must be at least a 22.2V 5000-6000mAh 50C battery. Your battery should be approximately the same capacity, dimen
sion and weight as the 22.2V 5000-6000mAh 50C Li-Po battery to fit the fuselage without changing the center of gravity signifi
cantly.
1.
2.
3.
4.
Get your model ready to fly