Operation Manual EMGZ490A
30.08.2019
27
8
Web Interface
8.1
Access to the Amplifier over a Web Interface
Parameter setting and calibration of the system can be performed over a web interface.
Using the web interface requires knowledge of the IP address. Your IT system
administrator can provide information about the assigned addresses. After entering the
IP address in your web browser the home page of EMGZ490A will appear (see Fig. 10).
Caution
The web interface may only be used in the test mode since data communication can
interfere with the PLC. Moreover, one link can be established via a web browser at the
same time.
Note
If you have connected a PLC to this amplifier, the PLC has be be on or at least set to „on
hold“. If the PLC is turned off, the web interface is disabled for safety reasons.
The Home page provides information on general device attributes like serial number
and the software version
Fig. 10: Home page with device information
With the menu on the left side of the screen you can navigate through the web page.
