FMS EMGZ490A, Operating Manual

Page: 17 / 36

Operation Manual EMGZ490A
30.08.2019 17
Tension at Max. Output
Use: This parameter defines what force value (N, kN, lb, g, kg) corresponds to
the maximum output of the amplifier (10V).
Note: By changing the units to lb the whole unit system will change from
metric to imperial units.
Unit
Parameter Range
Selection Default
Min Max
N, kN, g,
kg, lb
(1
0 200’000.000 - 1000.000
1)
The display shows the unit of measure that was previously selected.
Offset
Use: The value determined with the adjustment procedure Offset
Compensation is stored as a Digit value in the parameter Offset . The
offset value is used to compensate the weight of the measuring roller.
Unit
Parameter Range
Selection Default
Min Max
- -8000 8000 - 0
Gain
Use: This parameter stores the value determined with the Procedure
Calibration in the parameter Gain .
Unit
Parameter Range
Selection Default
Min Max
0.100 20.000 - 1.000
System Force
Use: The System Force determines the measuring capability of your
measuring roller. E.g. if two 500 N sensors are installed in your
measuring roller, enter 1000N. If only one 500N sensor is used, enter
500N. If sensors with sheaves are used (e.g. RMGZ-Series), 500N must
be entered.
Unit
Parameter Range
Selection Default
Min Max
N, kN, g,
kg, lb
(1
0 200’000.000 - 1000.000
1)
The display shows the unit of measure that was previously selected..