www.fmiproducts.com
125568-01B
29
VARIABLE REMOTE MODELS OPERATION
Continued
To activate this function, press THERMOSTAT
button until the word SMART appears to the
right of temperature bulb graphic on display.
Use UP/DOWN arrow button to set desired
room temperature. The control system will
cycle the fireplace on or off to maintain se-
lected temperature.
SMART
MAX
Figure 45 - Smart Thermostat Setting
ON
Figure 46 - Child Safety Lock-Out
CHILD SAFETY LOCK-OUT
This function lets you deactivate the remote
control buttons. It is active when the lock icon
is lit on the display.
To activate, press MODE button and UP ar-
row button at the same time. To deactivate,
press again.
REPLACING HAND-HELD REMOTE
CONTROL ONLY
If your remote ever needs to be replaced you
will not need to replace the receiver.
To program receiver with a new hand-held
remote, insert a small pin or paper clip into
hole on receiver face plate marked PRG. The
receiver will beep 3 times to indicate it is ready
to accept a new remote transmitter. Press
the ON/OFF button on your remote and the
receiver will beep 4 times to confirm it receives
commands from the new remote.
ON REMOTE OFF
PRG
To
Program
Receiver
Figure 47 - Programing Remote Control
to Receiver
Figure 48 - Correct Pilot Flame Pattern
Figure 49 - Incorrect Pilot Flame Pattern
Pilot Burner
Thermocouple
Thermocouple
Pilot Burner
Check pilot flame pattern and burner flame
patterns often.
PILOT FLAME PATTERN
Figure 48 shows a correct pilot flame pattern.
Figure 49 shows an incorrect pilot flame pat-
tern. The incorrect pilot flame is not touching
the thermocouple. This will cause the thermo-
couple to cool. When the thermocouple cools,
the heater will shut down.
If pilot flame pattern is incorrect, as shown
in Figure 49
• turn heater off (see To Turn Off Gas to Ap-
pliance, page 27
• see Troubleshooting, page 32
Note: The pilot flame on natural gas units will
have a slight curve, but flame should be blue
and have no yellow or orange color.
INSPECTING BURNERS
