24
CAST IRON STOVE AND BURNER SYSTEM
107599
For more information, visit www.desatech.com
1
2
3
4
It is very important to install these logs
exactly as instructed. Do not modify logs.
Only use logs supplied with burner system.
Do not use if any log(s) are broken (see
Replacement Parts, page 32).
1.
Remove glass door. See Removing/Re-
placing Glass Door, page 23.
2.
Place log #1 (back log) on top of grate.
Make sure the notches in the bottom of
the log fit over the grate (see Figure 57).
2.
Rest log #2 (large front log) on the pins on
the front part of the grate (see Figure 58).
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this burner system may re-
sult in property damage or per-
sonal injury.
INSTALLING LOGS, LAVA
ROCK, AND GLOWING
EMBERS
STOVE AND
DIRECT-VENT
BURNER SYSTEM
INSTALLATION
Continued
Figure 57 - Installing Log No. 1
Figure 58 - Installing Log No. 2
Figure 59 - Installing Log No. 3
Figure 60 - Installing Log No. 4
WARNING: The glass door
must be securely in place before
running this burner system. Do
not run this burner system if glass
is missing or broken.
NOTICE: Do not put lava rock on
burner or under burner. Placing
lava rock on burner could cause
performance problems.
3.
Place log #3 (crossover log) onto the
rear and front logs. Make sure it is seated
properly into the notch on the front log
and over the raised triangular portion of
the rear log as shown in Figure 59.
4.
Place log #4 (small log) onto the front
left part of the grate making sure the
notches fits over the prong of the grate.
See Figure 60.
Figure 61 - Placing Ember Material on
Burner
5.
Lava rock may be placed along sides
and front inside burner system bottom.
This may not be visible when you have
replaced the front of the stove. It is
not necessary to use all of the lava rock
provided.
6.
Pull ember material apart into pieces
no larger than a dime. Place these
pieces loosely and sparingly directly
onto the exposed section of the front
burner and along the space between the
burner and grate prongs (see Figure 61).
This will create the glowing ember ap-
pearance as the flame touches the em-
ber material. Do not block air slots by
using too much ember material in one
area. It is not necessary to use all of the
ember material provided.
7.
Replace the glass door and stove front.
See Removing/Replacing Glass Door,
page 23.
