FMI FSDVBNC, Owner'S Operation And Installation Manual

Page: 23 / 38

23 107599
OWNER’S MANUAL
For more information, visit www.desatech.com
LO
H
I
P
IL
O
T
OFF
ON
REMOVING/REPLACING
GLASS DOOR
CAUTION: Do not operate this
burner system with a broken
glass door panel or without the
glass door panel securely in
place. For replacement part in-
formation see
Replacement
Parts, page 32.
1. Remove 2 bolts from bottom of stove
(if still in place) and one from the top
of stove to remove front panel (see Fig-
ure 55).
2. Remove the screws from the 2 tabs at
the top of the glass door while holding
door securely keeping it from falling
forward (see Figure 56).
3. Grasp door by both sides and ease it
upward off of the lower bracket (see
Figure 56).
4. To replace glass door, follow the above
instructions in reverse.
You must remove glass door to install logs,
lava rock, and ember material. To remove
glass door, you must first remove the front
panel assembly on stove body if it has been
previously installed. If the front panel as-
sembly is not in place, proceed to step 2.
Figure 56 - Removing Glass Door from
Burner System
STOVE AND
DIRECT-VENT
BURNER SYSTEM
INSTALLATION
Continued
INSTALLING OPTIONAL
WIRELESS HAND-HELD
REMOTE CONTROL
ACCESSORIES - GHRC AND
GHRCTA SERIES
Figure 55 - Removing Front Panel from
Stove
Figure 51 - Installing Battery in Receiver
Figure 54 - Installing Battery in Hand-Held
Remote Control Unit (GHRCTA Series)
Installing 9-Volt Alkaline Battery
in Hand-Held Remote Control
Unit
1. Remove battery cover on back of re-
mote control unit
2. Attach terminal wires to a 9-volt bat-
tery (not included). Place battery into
the battery housing.
3. Replace battery cover onto remote con-
trol unit.
Terminal
Wires
Battery
Cover
9-Volt
Battery
Remote
Control Unit
Battery Housing
9-Volt Battery
Receiver
Battery
Clip
Terminal
Wires
Screw
Glass Door
Bolt
Bolt
Stove Front Panel
Assembly
Figure 52 - Installing Remote Receiver
Continued
Figure 53 - Installing Battery in Hand-
Held Remote Control Unit (GHRC Series)
Terminal
Wires
Battery
Cover
9-Volt
Battery
Remote
Control Unit
Battery
Housing
Installing Remote Receiver and
9-Volt Alkaline Battery
1. Open bottom door on stove body.
2. Disconnect wires from THTP and TH
on control valve that lead to the switch
(see Figure 48, page 22). Discard
switch plate, screws, and nuts.
3. Install 9-volt battery (not included) into
receiver battery clip and connect to ter-
minals (see Figure 51).
4. Place receiver into valve bracket and
align holes (see Figure 52).
5. Use push-in fasteners included with
receiver to secure to bracket.
6. Connect the wires from the receiver to
the valve at TH and THTP (see Figure
48, page 22).
Notice: Only use alkaline batter-
ies (not included).