Flyzone micro calypso, Instruction Manual

Page: 4 / 12

4
BEFORE OPERATING
Batteries for Transmitter
Remove
Battery
Cover
Confirm
Polarity
Markings
Re-Install
Battery
Cover
AA Alkaline
Batteries x 4
ASSEMBLY INSTRUCTIONS
NOTE: Use caution and care when assembling the parts so
that you do not damage them.
Tail Assembly
1. Install the horizontal stabilizer onto the tail of the fuselage.
Make sure the assembly keys onto the fuselage as shown.
Align the stabilizer 90° to the fuselage.
2. Install the vertical stabilizer onto the tail of the plane and
gently press it down until it locks into place.
3. Use the included tape strips to secure the aligned
horizontal stabilizer in place. Make sure the tape strips
wrap from the top of the horizontal stabilizer to the
bottom of the horizontal stabilizer and cover the front
plastic elevator supports.
4. Attach the elevator pushrod into the control horn on the
elevator and make sure that it snaps into place. Start
off by installing the elevator pushrod in the lower hole
for lower control throws (less responsive). Once you
become familiar with how the Micro Calypso flies, you
can install the elevator pushrod in the upper hole for
higher control throws (more responsive).
5. Attach the rudder pushrod into the control horn on the rudder
and make sure that it snaps into place. Start off by installing
the rudder pushrod in the outer hole for lower control throws
(less responsive). Once you become familiar with how the
Micro Calypso flies, you can install the rudder pushrod in
the inner hole for higher control throws (more responsive).
Center and adjust wire bends.