EN
GL
ISH
11
AS
SE
M
BL
y
OF
T
hE
B
-S
AF
E S
yS
TE
M
Thread the B-Safe top lines through the loop at the end of the
B-Safe line (5th line) of the CONNECT Control Bar.
Unfold the PEAK5 on the ground in front of you. Start in the
middle of the PEAK and lift the A-Level on either side of the wing.
Tip:
Go beneath the A-Level and lift it above your head. Put it
on the shoulder which points toward the middle of the PEAK5.
The lines of the B-Safe System run through the rings integra-
ted into the B-Level ribs. Search for the red LCL (Little Connection
Line) and connect the B-Safe Top Line with a Lark‘s Head knot.
Check if the B-Safe Top Line is correctly attached and runs
free beneath the A-Level. Repeat the process on the other side
of the PEAK5.
Use the CONNECT Control Bar with several PEAKs
Build a overhand knot at the end of the B-Safe Line (5th line).
Build two larks head knots at the end of the B-Safe Top Li-
nes. Attach both B-Safe Top Lines below the overhand knot of the
B-Safe Line (5th line) and pull them tight.
Unfold the PEAK5 on the ground in front of you. Start in the
middle of the PEAK and lift the A-Level on either side of the wing.
Note:
Leave the connection part where the 5,1 m B-Safe Lines
are connected to each other at the standard setting. The
variable connection part can be used to extend the total
length of the B-Safe line after heavy use.
Unwind the 7 m B-Safe Line from the cardboard winder.
Connect the 7 m B-Safe Line with the end of the of the 10 m
B-Safe Line.
Attention,
all line connections must be tight!
Thread the B-Safe Lines with a total length of 17 m through
the ring of the Front Connection Line.
Attention:
the B-Safe Pigtail with the double loop knot should
not slip through the ring!
The CONNECT2 Control Bar is now B-Safe System ready and ope-
rates on 5 flying lines.
08.02 Instalment of the B-Safe Top Lines on the
PEAK5
Take both grey B-Safe Top Lines (B-Safe Main) out of the side
pocket of the PEAK bag.
Keep the CONNECT Control Bar attached to one PEAK
This option offers the highest level of safety. We recommend if
you keep the CONNECT Control Bar attached to the PEAK.
Summary of Contents for CONNECT2
Page 1: ...USER MANUAL CONNECT2 EN...
