27
Function Settings:
1. Connect the FS-CVT01 sensor to the receiver"s SENS port.
2. Turn on the transmitter, enter the transmitter [Sensor] menu and select it from the [Sensor List]. If the sensor
displays External Voltage 12.4V then installation is complete.
3. Insert the red and black wire pins into the port on the battery. Red is positive and black is negative.
FS-CVT01 voltage acquisition module
The FS-CVT01 function is used to monitor the model battery voltage. To use this sensor connect it through the i-BUS
interface or connect to the SENSE port on the receiver directly.
FS-CAT01 altitude pressure module
The FS-CAT01 detects the altitude of the model using air pressure.
Function Settings:
1. Connect the FS-CAT01 sensor to the receivers SENSE port.
2. Use double sided soft tape to snugly fix the FS-CAT01 receiver in place.
3. Turn on the transmitter, enter the transmitter [Sensor] menu and select it from the [Sensor List].
• “Air pressure" is the name, "height" is the receiver type; "5" is the receiver ID, referring to the fifth receiver.
"1001.0hPa", "-14m" is the actual measured height value.
•
The actual air pressure and altitude can be calibrated in the Air pressure sensor] menu.
7.18.3 Air Pressure Sensor
Calibrates ground pressure.
Function Settings:
1. Connect an altitude pressure module then place the model on the
ground.
2. Use the + and – keys to adjust the altitude to 0.
•
Make sure your model is always at a level ground level during
setup.
7.18.2 Choose Sensors
This function is used to set the sensor data displayed on main interface, and to enable setting the current sensor
alarm threshold.
Function Settings:
The home screen can display up to 4 sensors.
1. elect a slot from the list. The slots will already have sensors
assigned to them and will have their names displayed.
2. [Sensor: name]: name being either non or a sensor name, is the
currently selected sensor. To select a sensor touch [Sensor: name]
then select a new sensor from the list.
3. Click
to enable the sensor alarm function and customize the
alarm value;
4. The receivers sensors will also be displayed in the list and can be
chosen as needed.
•
Once any sensor is set, the system will clear the default sensor
and sensor data, showing only the current sensor and sensor
data.
7.19 Help Center
This menu can allow you to obtain PL18EV instructions and records of software version updates.