15
7.3 Subtrim
This function is used to adjust the center point of each channel.
Due to the structure of some models the servos center point may need to be adjusted so that when at rest all the
control surfaces line up properly.
When using this function make sure that the stick, knob etc. is at its center position.
7.4 Conditions
Conditions is divided into move mode and work mode. The two modes can be done with different settings to
achieve the same operation in different modes corresponding to different effects. When the same stick is used to
control the mobile mode or arm, this function can be used to assign the control mode in two working modes for
achieving the menu switch. The title shows the current conditions state. You can set the function parameters to
save the current conditions.
Function Settings:
This function adjusts the subtrim of the 18 channels in a range from
-120% to 120%, corresponding to a channel ratio of -24% to 24%.
Steps:
1. Select a channel.
2. Use the + and – icons to adjust the channels center point.
Function Settings:
Click on the conditions to select the move mode and work mode.
The move mode is the system default mode.
Steps:
1. Select the work mode, and click to enter the submenu;
2. Enable this function, and toggle the corresponding button or
switch. Click Return to save setting;
3. Toggle this switch to change the work mode.