17
Switches, knobs etc. can be assigned to control the function by touching the
icon.
[Dual switch]: A switch (or logical switch) can be selected to switch between two groups of Rates and Exponents.
a. Touch the
icon to enable. Then select a switch and switch position.
b. Use the back icon to go back to the functions Rate and EXP menu and set the parameters as needed.
c. Toggle the switch (or logical switch) (SWB to the down position) to switch to the second group of rates and
exponent parameters, and set the parameter of the second group of rates and exponents;
d. Toggle the switch again to check whether the first and second groups of rate and exponent parameters are set
successfully.
2. Select [Rate] or [EXP];
3. Click "+" "-" on the screen to adjust the tilt and curvature of the curve.
7.7 Channels Offset
This function allows you to adjust the overall offset of each channel data. The offset caused by the model can be
corrected using this function. If the offset is set too much, the control amount of one end of the channel is reduced.
If the model deviation is large, please try to adjust the model first.
Function Settings
This function can be used for all 18 channels and has a range of
-150% and 150%.
1. Select a channel.
2.
Use the + and – icons to adjust the offset.
7.8 Channels Delay
This function is generally used to prevent the model structure from being damaged by the instantaneous large
speed of the servo, or to achieve a certain effect by limiting the speed of activity.
Function Settings:
This function allows you to set the delay time for 18 channels.
Steps:
1. Select the channel to be set and access the submenu;
[Value] indicates the delay time of the whole process from
the lowest to the highest value of the current channel. The
adjustment range is between 0-10 seconds (every 0.1s is a unit).
The green in the coordinates indicates the real-time position of
the stick.
2. Use the + and – icons to change the delay time.