6
USE
line cutter
D
E
F
How the automatic line feed works
How to trim
1. A short length of new line is fed out
every time you switch on, this is
caused by the cutting head
accelerating up to its full speed.
2
To feed more line, it is necessary to
switch-off, allow the motor to stop
and then restart.
3. When line feeds you will hear a
change in the motor sound as well
as the noise generated by the line
being cut to length.
4. If the line does not feed see Fault
finding hints on page 10 for further
information.
•
WARNING
The use of eye protection is
recommended. Do not lean over
the trimmer guard whilst
trimming, objects may be thrown
by the cutting line. Do not allow
cutting head to rest on the
ground. Do not overload your
trimmer. Overloading can be
avoided by making sure the motor
speed does not drop unduly.
Disconnect from the mains
electricity supply before
attempting any maintenance or
adjustment.
1. Cut with cutting line at an angle
using the tip.
2. Swing trimmer in and out of the
cutting area taking small cuts.
