8
USE
Nylon Line
J
Do not depress the button more than three
times. Excessive line will snag the line
cutter and cause the trimmer to
malfunction.
L
K
hole in spool
line
eyelet
To manually feed the nylon line
If required, line can be fed out
manually. To operate, gently pull on the
line whilst alternately pressing and
releasing the button, on the side of the
spoolholder. See fig J.
To replace nylon line. Replacement
nylon line is available from most
Electrolux Outdoor Products stockists.
You can buy it either as spool and line
complete, or as nylon line only.
To replace spool and line (complete)
1. Take new spool and remove tape
holding line in place.
2. Unwind approximately 100mm of
line and feed this through eyelet,
see fig K, then drop the spool into
spoolholder smooth side
uppermost.
To replace nylon line on spool.
1. Take line and insert into hole in
spool.
2. Turn spool clockwise to wind on
required amount of line, (approx.
half = 10m) and cut line to length,
see fig L. Care should be taken to
ensure that the line is neatly coiled
on the spool. Failure to do so will
impair the efficiency of the
automatic line feed.
3. Leave approximately 100mm of line
unwound and feed this through
eyelet, see fig K, then drop the
spool into the spoolholder smooth
side uppermost.
•
Ensure spool is fully located by
gently rotating it during fitment.
•
Remember ! Your Flymo Trimmer
is designed to use only nylon line
with a maximum diameter of
1.5mm. Use only genuine Flymo
nylon line.
