Thermal
Imagers
Maintenance
29
Note
Minor smudges and grime should not significantly affect the
performance of the Imager. However, large scratches or the removal
of the protective coating on your infrared lens may affect both image
quality and the temperature measurement accuracy.
Note
Use of alcohol, abrasives, solvents, or harsh detergents could damage
not only the protective optical coating on the infrared lens, but also
the sealing materials, rubber components, and adhesives in the lens
assembly. Use of these items to clean the Imager or thermal lens will
void the warranty.
Battery Care
To get the best performance from the Imager’s rechargeable Lithium-ion smart
batteries, use the guidelines that follow.
W
Caution
To avoid damage to the Imager, do not leave the camera
exposed to a heat source or high-temperature
environments, such as an unattended vehicle in the sun.
Do not store the Imager on the power supply/charger for more than 24 hours as
reduced battery life may result.
Charge the Imager’s Lithium-ion smart batteries for a 2-hour minimum at least
every six months to maximize battery life. Without use, the batteries will self-
discharge in approximately six months. Batteries stored for long periods may
require two to ten charging cycles before it reaches full capacity.
Always operate the Imager within the temperature range specified in the
specifications labeled Temperature – Operating.
~
W
Caution
Do not incinerate the Imager or battery. Go to Fluke’s
website for recycling information.
Summary of Contents for Ti32
Page 6: ...Ti32 TiR32 Users Manual iv ...
Page 40: ...Ti32 TiR32 Users Manual 34 ...