Fluke Ti30, User Manual

Page: 29 / 104

Note:
To erase an image, just store a new image over the one you wish to delete. To do
this, go to Recall Images Procedure, press the
Down or Up buttons to find the
image location number you wish to delete, press Mode button or trigger to get back
to measurement mode, and pull trigger again to save a new image in that location.
There is also a procedure to erase an entire session (all images on the Ti30 Imager)
using the “Clear images in imager” button in the InsideIR software.
Retrieving an Image
From Measurement mode, press the MODE button 3 times, browsing through
Emissivity Adjustment and Reflected Temperature Adjustment modes (these
adjustments are explained in Chapter 3 ). The thermal image and related data of the current
location is shown on the display. Use the
Up and Down buttons to scroll through the
images you have previously recorded. All stored images can be downloaded to your
computer for analysis using the InsideIR software later. To go back to measurement mode
just pull the trigger or press the
MODE button once more.
High alarm
Reflected Temperature
Compensation (RTC) value
Date stamp
Temperature scale
Location name
Stored image
Low alarm
Time stamp
Stored target temperature
Emissivity value
Figure 16. Retrieve Mode
The next chapter, Downloading and Looking at Images, leads you through installing the
InsideIR software. You may then start downloading your images to your computer.
Jan 31st, 2005 - 29 -