Thermal Imager Camera
Accessories
35
Figure 36: Dimensions and Footprint of Outdoor Enclosure (A-TV-ENC)
Installation
•
Locate 2x M4 screws on camera
•
Place conduction plate onto camera as shown, making sure to line up holes on camera with
hole and slot on the conduction plate.
•
Install 2x M4 screws and secure conduction plate onto camera.
•
Place housing internal rail onto conduction plate as shown.
•
Secure conduction plate to rail by installing 2x Screws (truss),
4x curved washers (2x per screw), and 2x flat washers.
Insert each screw half a turn past after contacting curved washer
and slide camera forward.
•
Secure ground cable to camera as shown (color of cable/ring terminals used for display
only), from camera to internal rail screw with tooth washer. Then install supplied ground
cable onto heater board for connection to enclosure.
•
Disassemble Ethernet cable connector by loosening nut as shown.
•
Remove cable from RJ45 jack by lifting tab, note wiring for reassembly.
•
Pass Ethernet cable through enclosure cable gland as shown and reassemble connector.
•
Insert power cable with isolated cable ends through cable gland on enclosure.
•
Using power and Ethernet cables that have been passed through cable glands on rear of
enclosure, install cables onto camera (turn on camera if needed).
