T+/T+PRO English Instruction Sheet
Page 2
Safety Information
XW
Warning
To avoid possible electric shock or personal injury,
follow these guidelines:
•
Use the Tester only as specified in this
instruction sheet, otherwise the protection
provided by the Tester may be impaired.
•
The Tester is to be used only by qualified
personnel.
•
Do not use the Tester if it is damaged. Inspect
the case before use. Look for cracks or missing
plastic. Pay particular attention to the insulation
surrounding the connectors.
•
Inspect the test leads for damaged insulation or
exposed metal. Check the test leads for
continuity. Replace damaged test leads before
using the Tester.
•
Do not use the Tester if it operates abnormally.
Protection may be impaired. When in doubt, have
the Tester serviced.
•
Do not operate the Tester around explosive gas,
vapor, or dust.
•
Do not apply more than the rated voltage, as
marked on the Tester, between terminals or
between any terminal and earth ground.
•
When measuring hazardous voltage, verify the
Tester’s operation by measuring a known
voltage.
•
Only the test probes and batteries are
serviceable. When servicing, use only specified
replacement parts.
•
To determine the LEDs and beeper are working
correctly, short the test leads together. The
beeper sounds (if enabled) and all LEDs and
display segments (T+ PRO) switch on briefly
indicating correct operation.
•
Comply with local and national safety
requirements when working in hazardous
locations.
•
Use proper protective equipment, as required by
local or national authorities when working in
hazardous areas.
•
Use caution when working above 30 V ac rms, 42
V peak, or 60 V dc. Such voltages pose a shock
hazard.
1.800.868.7495
Fluke-Direct
.ca
