Controller Operation
8.2 Temperature
Set-point
8
8-3
Well temperature in degrees Celsius
Access
set-point
memory
Set-point memory 1, 200.0°C currently used
To change the set-point memory press “UP” or “DOWN”.
New set-point memory 5, 900.0°C
Press “SET” to accept the new selection and access the set-point value.
Accept selected set-point memory
8.2.2 Set-point
Value
The set-point value may be adjusted after selecting the set-point memory and
pressing “SET”.
Set-point value in °C
The first digit flashes on and off. If the set-point value is correct, press “EXIT” to
display the temperature scale units.
If the first digit is correct press “SET”.
To adjust the first digit, press “UP” or “DOWN”. Then, press “SET” to go to the
second digit. The second digit of the temperature should now be flashing. Adjust
this digit by pressing “UP” or “DOWN”.
Press “SET” to accept the second digit and repeat until the last digit has been
adjusted.
New set-point value
Press “SET” to accept the new set-point. If “EXIT” is pressed all changes made
to the set-point are discarded.
Accept
new
set-point
value
www.
GlobalTestSupply
.com
Find Quality Products Online at:
