Replacement Parts
9
3
Pull the RJ45 jacks off the circuit boards (Figure 3), being careful not to stress the
boards.
4
Align the new RJ45 jacks on the connectors on the circuit boards. Note in Figure 3
how the insulation displacement connectors in the jacks slide into the connectors on
the circuit boards.
5
Place the boards on a hard, flat surface; then push the RJ45 jacks onto the
connectors on the boards. If firm pressure does not push the jack onto the
connectors, realign the jack on the connectors before trying again.
6
Reassemble the cases.
7
If the adapters' performance was characterized when the adapters were new, use
the results and the reference patch cord to check the adapters' performance. See
Appendix A.
Insulation displacement
connectors in RJ45 jack
Connectors on
circuit board
h
bal11f.eps
Figure 3. Replacing the RJ45 Jack
Replacement Parts
Table 1 shows the replacement parts available for the DTX-PCU6S Patch Cord Adapters.
The parts are available from Fluke Networks, unless otherwise specified.
Table 1. Replacement Parts
Description
Fluke Networks Model Number
Kit of 10 RJ45 test jacks for DTX-PCU6 adapters
DSP-PCI-C6JACK
DTX-PCU6 Cat 6 patch cord adapter for main tester
DTX-PCU6/MN
DTX-PCU6 Cat 6 patch cord adapter for remote tester
DTX-PCU6/SR
Superior Modular Part Number*
Set of two RJ45 Cat 6 test jacks for DTX-PCU6 adapters
PCTAC6K
Set of two RJ45 Cat 5e test jacks for DTX-PCU6 adapters
PCTAC5e
* Superior Modular Products
33 Superior Way
Swannanoa, NC 28778, USA
Telephone: 1-828-298-2260 or 1-800-880-7674
World Wide Web: www.superiormod.com
