DSX-602 CableAnalyzer
Users Manual
42
WIRE MAP Tab
The
WIRE MAP
tab shows the connections between the ends of
the cable under test. The tester compares the connections to the
selected
Outlet Configuration
to get a
PASS
or
FAIL
result.
If the wire map test fails, you can continue or stop the Autotest.
Or, you can tap
SCAN ON
to do the wire map test continuously
while you look for the fault. To continue the Autotest after you
correct the fault, tap
SCAN OFF
, then tap
CONTINUE
.
If you leave then return to the
WIRE MAP
FAIL
screen, the
SCAN
ON
button goes away. To see the button again, tap
TEST AGAIN
.
You can also select the continuous wire map test as a single test
from the
TOOLS
menu. See “Continuous Tests” on page 51.
Figure 16 shows an example of a wire map screen. For
information on AC wire map screens, see the Technical Reference
Handbook.
BA59.EPS
Figure 16. WIRE MAP Tab
A
D
E
F
B
C
