Fluke Calibration RUSKA 7615, User Manual

Page: 24 / 64

RUSKA 7615
Users Manual
3-2
Table 3-1. General Specifications & Parameters
Parameter Value Model
Operating Humidity Range
Storage Humidity Range 5% to 95% RH
None1 all
Operating Temperature
Storage Temperature 5 °C to 50 °C
-20 °C to 70 °C all
Air Supply – Pressure Range
Min. Dew Point
Peak Flow Capacity
100 – 110 psig
-10
o
C
300 SCFH
all
Power Requirements 115 VAC or 230 VAC all
Warm Up Period < 30 min. all
1
Note: If there is any condensation, the Calibrator must be thoroughly dried
before power is applied.
Cautions
The following cautions should be heeded at all times to insure safe operation of the
Calibrator.
WX
Warning
Never operate the unit with the cover removed. The power
supply has internal voltages near 400 volts.
Never apply more than 110% of the unit’s full scale pressure range to the test port. Never
try to control while a pressure source is connected to the test port.
Avoid thermal and mechanical shock to the instrument. This will affect performance and
require re-zeroing.
W
Caution
Never operate the unit without a minimum volume of 3 in
3
(50 cc)
attached to the test port. This can result in damage to the
sensor.
Powering Up the Calibrator
1. First, plug the power cord supplied with the Calibrator into the power connector on
the Calibrator’s rear panel.
Note
Grounding for the Calibrator is provided through the power cord.
2. Next, plug the power cord into a receptacle rated for either 115 VAC or 230 VAC
(check name plate). If a different power cord is necessary for your receptacle, consult
Chapter 1, Table 1-2, for available power cords.
3. Finally, turn on the Calibrator by flipping the POWER switch on the rear panel. In
about 10 seconds , the MEASURE screen will appear on the vacuum fluorescent
display, and the front panel will be fully operational.