Fluke Biomedical Victoreen NERO mAx 8000, User Manual

Page: 30 / 98

Victoreen 8000
Operators Manual
2-18
If results are to be printed, plug the printer cable into the printer port at the rear of the NERO mAx then
plug the other end of the printer cable into the printer and turn the printer on (see Section 1.5--Printing).
Plug the AC adapter into the NERO mAx if needed (see Section 1.4--Battery Operation and Charging)
and turn the instrument on.
EXP
CT EXP
AMSE
FLUORO Mo 30
μ
MAMMO LOW RHODIUM Rh 25
μ
RADIO HIGH MOLY Al 1MM 0 ms
MODE SENS TARGET FILTER DELAY
Select the MAMMO mode, high or low sensitivity, target and filter and shot delay, then press the ENTER
key. To use a measurement delay, press the DELAY key to select and increment the shot delay. The
measurement delay may also be incremented or decremented by pressing the up or down keys when the
delay is selected. The measurement delay is retained from one exposure to the next and can only be
reset to zero by the user.
Please wait…
FILTER = 22 - 35
MAMMO HIGH MOLY Mo 30
μ
0 ms
MODE SENS TARGET FILTER DELAY
Please wait while the NERO mAx prepares to take an exposure. Note that the selected filter kV range is
displayed. If the NERO mAx detects a fault condition such as an invalid filter card or position, an error
message is displayed and the user must correct the error to continue (see Section 4.3--Error Messages--
for more information). When the NERO mAx is ready to take an exposure it will beep and prompt for an
exposure.
MAKE EXPOSURE
FILTER = 22 - 35
MAMMO HIGH MOLY Mo 30
μ
0 ms
MODE SENS TARGET FILTER DELAY
Make an exposure. If nothing happens, there is insufficient x-ray intensity to make a measurement. To
remedy this situation, switch to high sensitivity, increase mA or decrease the distance between the x-ray
tube and NERO mAx detector.
ANALYZING DATA
FILTER = 22 - 35
MAMMO HIGH MOLY Mo 30
μ
0 ms
MODE SENS TARGET FILTER DELAY
Please wait while the NERO mAx analyzes the exposure data.