Flow Fitness Glider DCT1200i, Manual

Page: 96 / 100

96 - Manual Glider DCT1200i
5. General information
Problem
During a training the crosstrainer makes beeping or scratching noises.
Solution
Beeping or scratching noise are mostly caused by the plastic cover hitting or
scratching the metal frame. The solution to this problem is to spray this components
with WD40. WD40 is available in hardware stores.
Problem
De computer doesn’t or badly reads your heart rate.
Solution
Receipt of the heart rate with use of the handle bar sensors is not consistent. Sweat,
movement or even hand creme can have a negative effect on the connection.
We advise you to use a chest belt while training a heart rate controlled exercise
program. The handle bar sensors are primarily used for occasionally checking the
heart rate during a training excises.
When there is no heart rate reception when using a chest belt check the following:
-Is the chest belt coded? Coded chest belts don’t work on our equipment. The chest
belt must be “Polar Compatible” and send a 5 kHz signal.
-Have you read the chest belt’s manual? It is important that the sensors are made
moist for a better contact with the skin.
-Is there a full and correctly placed battery?
-Is the chest belt worn tight enough?
In case your problem is not resolved or not described, consult the fitness dealer
where you purchased this product.
5.3 Troubleshooting