Florite N920 Series, Instrument Training Manual

Page: 47 / 55

Port Type - Output Program
Function
This screen is used to program an output (or input) port for the installed port module. The output Port
Type may be programmed to service the selected output signal Type and Link.
Navigation
Access this screen by using the CHAN key until reaching the desired port number, and then by using
the PROG key until reaching this screen. Note the display Type field portion blinks indicating
readiness for programming.
Select
ƒ
Field - independently select the signal type field or link field using the QTY (right) or CHAN
(left) keys.
ƒ
Type Field - select the output signal type by pressing either the ZERO (down) or RATE (up)
key to select one of the following:
o
Volt (0-10V)
o
Current (0-20mA)
o
Relay
ƒ
Link Field - select the link port number pressing either the ZERO (down) or RATE (up) key.
The link port number is the input port from which the output port acquires measurement values
used by the output port to perform its selected Control Type function.
Program - save new Type and Link selections by pressing the PROG key.