FLORABEST 273466, Operation And Safety Notes

Page: 34 / 43

30 GB/MT
–
System time
– Irrigation start time 1
–
Irrigation duration 1
– Irrigation start time 2
– Irrigation duration 2
– Irrigation interval (every day, every 2nd day,
every 3rd day, etc.)
–
Standby (Programming mode terminated and
irrigation programme active).
¾
After about 1 minute without any entries being made,
the appliance returns to standby mode. All values
that have already been programmed are retained.
¾
By briefly pressing the button
8
you can jump
back one step in the programming mode to make
adjustments to the programmed values.
¾
By pressing and holding the button you can
terminate programming mode and the values that
have already been programmed will be retained.
¾
Press the button to stop irrigation that is already
in progress.
§
Battery charge level
¾
In the event of a low battery charge level,
the
symbol
C
flashes. All other displays are
deactivated.
symbol flashes on the display
2
The batteries are flat.
Valve does not open.
The appliance cannot carry out irrigation.
The batteries must be replaced
(
→
Inserting/replacing the batteries).
¾
For as long as the symbol flashes, irrigation is
not possible. Irrigation that may be in progress will
be terminated.
¾
The programming is saved for 120 seconds. If battery
replacement takes longer, the appliance must be
reprogrammed.
§
Troubleshooting
Fault Possible cause Solution
No indications on
the display
2
No batteries
inserted
Insert batteries
Batteries are
discharged
Replace the
batteries
Irrigation does
not commence
Water tap
closed
Open the water
tap
Incorrect
programming
Check the
programming
No batteries
or discharged
batteries
Insert/replace
batteries
§
Cleaning and care
CAUTION!
Possible damage to the appliance.
Moisture can cause damage to the appliance. To avoid
irreparable damage to the appliance, ensure that no
moisture can penetrate into the battery compartment
10
during cleaning.
¾
Clean the housing only with a soft damp cloth and a
mild detergent.
¾
Do not use any solvents, petrol or similar items. This
would damage the device.
§
Cleaning the sieve
¾
The sieve
11
should be checked regularly and
cleaned when necessary.
¾
Close the water tap.
¾
Allow the appliance to drain.
¾
Unscrew the union nut 1 from the thread of the
water tap or the adapter.
¾
Remove the cone-shaped sieve from the water supply
in the union nut.
¾
Clean the sieve.
¾
Replace the sieve.
¾
Screw the union nut onto the thread of the water tap
or the adapter.
¾
Open the water tap.