29
GB/MT
§
Inserting/replacing the
batteries
¾
Open the battery compartment
10
.
¾
Insert 2 AA size batteries (LR06/Mignon) in the
battery compartment
10
. Ensure that the polarities
are correct according to the polarity markings on the
battery compartment and batteries.
¾
Carefully close the battery compartment.
¾
The display
2
is switched on and the system time
starts at 0:00 hrs.
§
Installation
For the safe and trouble-free operation of the appliance,
the following requirements must be met at the installation
location:
¾
The temperature of the water flowing through the
computer may not exceed 40°C.
¾
Minimum operating tempe5°C.
¾
Use only clean, fresh water.
¾
Connect the appliance vertically, with the hose
connection
9
at the bottom in order to prevent water
entering into the battery compartment
10
.
CAUTION!
The irrigation computer may only be
connected to a drinking water outlet with a protective
appliance that complies with at least type HD
according to EN 1717 (backflow preventer with pipe
ventilation).
NOTE:
Suitable adapters are available from
specialist shops.
¾
Check the type of available water outlet. The
appliance is equipped with a union nut
1
for water
taps with a 33.3 mm thread (G 1”).
The adapter
12
is used to connect the appliance to
water taps with 26.5 mm thread (G
³⁄
4
”
).
¾
Insert the sieve
11
into the union nut
1
according to
the position shown in the picture on the fold-out page.
¾
For 26.5 mm threads (G
³⁄
4
”
): Screw the adapter
12
to the water tap manually. Do not use pliers.
¾
Screw the union nut
1
onto the thread of the water
tap or the adapter manually. Do not use pliers.
¾
Screw the
hose connector
13
onto the hose
connection
9
. A hose can then be connected to the
hose connector
.
¾
Open the water tap.
¾
If leaks/leakages occur when using the adapter
12
,
wrap some sealant tape around the thread of the
water tap.
§
Operation
Please refer to the fold-out pages for operation and
programming of the appliance. All required steps are
graphically displayed here.
¾
Switching¾the¾appliance¾on/off:
See Figure 1.
¾
Setting¾time:
See Figures 1–6.
¾
Programming¾irrigation¾1¾and¾2:
See Figures 7–26.
¾
Setting¾the¾irrigation¾interval:
See Figures 27–29.
¾
Starting¾manual¾irrigation:
See Figure 30.
¾
Setting¾start¾time¾for¾manual¾irrigation
:
See Figures 31–35.
NOTE:
The manually set irrigation time will be saved
and automatically set for the next manual irrigation.
To change the irrigation time follow the instructions as
in Fig. 31–35.
¾
Ending¾manual¾irrigation:
See Figure 36.
¾
Note that for certain functions you must press and
hold the button for a few seconds, according to the
diagrams on the fold-out pages. For other functions
briefly pressing is required.
¾
Activate programming mode by pressing the button
5
. You can either make all the settings one after the
other or switch between the following setting options
by pressing the but
ton
5
:
Summary of Contents for 273466
Page 3: ...11 13 12 1 2 4 5 3 6 7 9 10 8...
Page 4: ...B C D E F G H I J A...
