Flora Digital Printing System
Model LJ320P
Copyright 2011@ Shenzhen Runtianzhi Image Technology Co.,Ltd. By Victor Xu
~ 9 ~
electrical connection regulation. The ground voltage should be less than 3 V.
Set the machine on smooth ceramic tile or cement ground
Use specified anti-static floor mat to minimize harmful static build-up.
1.2.7 Printing media rolls are bulky and very heavy
Wear hand and foot safety protection gear when loading, unloading and handling
media to avoid serious body injuries.
Use proper heavy duty handling equipment if available.
1.3 Fireproofing
Ink and Solvent should be clearly labeled and stored in a specific area for flammable liquid and
should be in accordance with local regulations of fireproof and safety standard. Ensure that the specified
fire extinguisher is always available near the storage area and should be cleared from any obstacle in
case of emergency.
1.4 Exhaust System
The printing area should be equipped with sufficient exhaust system. The exhaust should be installed
in such a way build up of fumes is minimized. Best location for the exhaust should be at lowest level, this
way the fumes build-up is minimized. Solvent fumes are heavier than air, so fumes build-up concentrates
on the lower level of the room.
1.5 Handling Precautions
1.5.1 Power Supply
Install the printer near an easily accessible electrical outlet.
Do not provide power to the printer through the same power line as for other noise
generating devices such as motors.
Use a power supply matched with the printer specification.
Connect the power cable directly to an electrical outlet. Do not plug several devices
into one electrical outlet.
1.5.2 Printer
Do not place anything on top of the printer.
Do not rest you elbows on the printer.
Open and close the top cover gently from the front of the printer with both hands.
Before connecting or disconnecting the interface connector, turn the printer OFF.
Do not clean the surface of the cover with benzene or paint thinner. The coating may
come off or deteriorate. Wipe the cover with a soft cloth, if the cover is very dirty, use a
cloth moistened with a neutral detergent.
Do not touch the ink jet head surface.
1.6 Regular Inspection and Maintenance
The following regular inspection and maintenance must be performed in terms of characteristics of
the solvent ink:
a)
Clean the carriage unit and the flat table conveyor surface every day.
b)
Make sure that the carriage covers are always replaced.
c)
Perform ink supply circuit and print head cleaning when leaving the printer for a long
time (2 weeks or more with no power).
d)
Perform head cleaning after leaving the printer idle for a long time.
e)
Shut off the solvent lamp whenever the printer is not in use.
1.7 Consumables
z
Always use the recommended consumables (printing media, ink, ink filters). Failure to
follow this instruction may cause poor printing quality and breakdown.
z
Do not use ink past the expiration date as this may cause a print head breakdown and poor
printing quality.
