Initial Startup
The Sweeping & Suction Machine standard delivery is
without batteries or charging device.
Optional:
the Sweeping & Suction Machine is supplied with batteries
•
Open the transport packaging.
•
Take off the complete hood. Lift up hood at back and lift
the front spigots of the hood out of the retaining.
•
Fit in the batteries.
•
Connect the batteries. Compare technical data circuit
diagram.
•
Replace the hood panel.
•
Mount the side brushes
(cf. Mounting the Side Brushes, page 15).
The Sweeping & Suction Machine is ready for use.
•
Drive the Sweeping & Suction Machine over a ramp out
of the transport packaging.
Use a unit ramp. The ramp must be designed in
such a way as to allow the rear wheel as well as
the drive wheels to travel across it.
If this is not observed, damages to the Sweeping
& Suction Machine mechanics will occur.
Standard
:
Optional
:
.
The Sweeping & Suction Machine is equipped with
batteries.
•
Open the transport packaging.
•
Open the hood
•
Lock hood securely using the hood arrester.
The hood is equipped with drill holes at the bottom
•
Fit the hood arrester into the corresponding drill hole.
•
Connect the positive pole of the battery.
•
Close the hood.
•
Mount the side brushes
(cf. Mounting the Side Brushes, page 15).
•
Drive the Sweeping & Suction Machine over a ramp out
of the transport packaging. (Cf. page 8, Driving)
Use a unit ramp. The ramp must be designed in
such a way as to allow the rear wheel as well as
the drive wheels to travel across it.
If this is not observed, damages to the
Sweeping & Suction Machine mechanics will
occur.
The Sweeping & Suction Machine is ready for use.
Safety Devices
The Sweeping & Suction Machine only can be started if
the battery master switch (EMERGENCY OFF) and
the ignition key are both set to the ON position
the control panel switch for the direction of motion
is in the neutral position
If the main switch is set to reverse motion, an acoustical
signal is heard.
-
;
-
.
If the fuel pedal is depressed during the starting procedure,
the power supply to the driving motor is interrupted.
Power supply to the electric motor is interrupted, if
the hood is opened;
the driver's seat is not weighed down;
the EMERGENCY OFF switch is actuated.
-
-
-
7
Unit Ramp
Elements of the Transport Packaging.
.