FLIR Raymarine HD DIGITAL RADOME, Installation Instructions Manual

Page: 45 / 64

Radar scanner connection
The power and data cable connector is at the rear of the radar scanner unit.
Ensuring that the arrow on the power and data cable connector is aligned with the red triangular
mark on the radar scanner connector, connect the cable to the scanners' connector, and fully
hand-tighten. Do NOT use a wrench or any other tool.
Note: If the antenna connector is disconnected after initial installation, Raymarine recommends that
before reconnecting, you lightly coat the connector thread with Renolit Aqua 2 Calcium grease.
Display connection
The correct connection to your multi-function display depends on whether you have a SeaTalkhs or
RayNet network connector on your multi-function display.
Refer to the relevant system diagram in the following typical system example chapters:
• For RayNet multi-function displays, refer to: p.25 — Typical system examples - RayNet displays
• For SeaTalkhs multi-function displays, refer to:
p.29 — Typical system examples - legacy SeaTalkhs displays
Connections 45