FLIR Raymarine HD DIGITAL RADOME, Installation Instructions Manual

Page: 52 / 64

12.1 Switch off power
Short desc is not printed, but is used in searches
Before commencing any maintenance task, switch off all power to the product.
12.2 Service and maintenance
This product contains no user serviceable components. Please refer all maintenance and repair to
authorized Raymarine dealers. Unauthorized repair may affect your warranty.
12.3 Routine equipment checks
It is recommended that you perform the following routine checks, on a regular basis, to ensure the
correct and reliable operation of your equipment:
• Examine all cables for signs of damage or wear and tear.
• Check that all cables are securely connected.
12.4 Maintenance
Once a year:
1. Remove one of the antenna-securing bolts and associated washers.
2. Clean the bolt and washers.
3. Use Denso paste to lightly re-grease the bolt thread.
4. Replace the bolt and associated washers.
5. Repeat steps 1 to 5 for all antenna-securing bolts.
6. Tighten all antenna-securing bolts to a torque of 20 Nm (177 lbf/inch).
Periodically, carry out these other maintenance tasks:
• Ensure the antenna is firmly attached to the mounting surface
• Check that the cable connections are in good condition and securely attached.
• Examine all cables for signs of chafing, cuts or other damage. If the antenna connector shows
any sign of corrosion:
1. Disconnect it.
2. Clean the connector.
3. Lightly re-coat the connector threads with Renolit Aqua 2 Calcium grease.
4. Reconnect and hand-tighten the connection until it is secure.
12.5 Product cleaning
Best cleaning practices.
When cleaning products:
• Switch off power supply.
• Lightly rinse or flush with clean, cool fresh water.
• Do NOT use: abrasive, acidic, ammonia, solvent or other chemical based cleaning products.
• Do NOT use a jet wash.
52