427-0033-00-12 Version 110
February 2019
55
This document does not contain any export-controlled information.
Advanced Configuration
Video Analytics Alarm to Email:
Shown at the
right is an example of an alarm rule that causes an
email notification (with a snapshot image) to be sent
when a motion alarm occurs in Analytics Region 0 or
Region 1 (Area or Tripwire). Refer to
).
The Alarm Source Device Type is set to
Video
Analytics
with Alarm Id set to “
1
” corresponding to
Analytics Area 1.
The
Send Notification
action uses a Msg System
and a Notification List that are set up in the Services
menu (refer to
Services > Msg Systems, pg. 24
). The
email includes alarm information, including the Area
ID and if it is a human or vehicle alarm. When an
email is sent, the Alarm Manager can attach a
snapshot from the camera to the email. In Attach
Image File,
All Non Radiometric
is selected for the
type of image.
After making any changes you must scroll to the
bottom of the page and click on the
Save
button to
save settings. Changes will not take effect until the
server is stopped and started.
GPIO Input to Snapshot:
In the example rule shown
at the right the source type of the alarm is GPIO, with the
Input ID set to 1, which corresponds with the input IO 1
), then takes a snapshot
and stores it locally onboard the camera and/or over the
camera network using FTP or an NAS server.
The Action is set to
Capture Image File
; a snapshot is
stored when the alarm occurs. The image file can be stored
locally in temporary storage (the default), over the camera
network using FTP (file transfer protocol) or to a network-
attached storage device (NAS). Refer to
to configure settings for the FTP, NFS, or Samba transfers.
Click Save
Stop and Start Server
