FAA-28, Technical Manual, Rev.1.1.0
February 2022
Page 18 of 21
7. Programming With xFace Software Over RS232
FAA-28 has RS232C serial interface to perform eCal electronic calibration and to
adjust filter, setpoint values and to follow status by using
xFace
software installed on
a PC.
For installing the xFace software, which is supplied with the instrument or can be
downloaded from
, follow the steps described below.
7.1
Installation of xFace Software
•
Close all applications on your PC
•
Insert the CD that contains the xFace software v2.03 or higher into the CD-
ROM drive
•
Double click “Setup.exe” to start the installation. The setup Wizard will be
displayed
•
Follow the menus in the setup wizard step by step
•
After finishing the installation, the Setup Wizard will inform you about the
success of the software installation. Click the OK button
•
After closing the Setup Wizard you can start to use the xFace software
7.2
xFace Software
For programming instrument via xFace follow the instructions below;
1. Power off the instrument.
2. Connect the instrument to PC as
to use xFace
software and run the software.
Select FAA-28 and press
“OK”
button.
3. Select the Com-port and press
on “Connect” to connect to
the instrument.
