Flintec CC1W-30klb, User Manual

Page: 20 / 22

User Manual - CC1W
V1.2 – ISSUED 17 AUG 2020 Page 20 of 22 DOC No. 0095771
FCC Certification Statement
Note: This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device has been designed to operate with the antenna(s) listed below, having a
maximum gain of +3.2dBi. Antennas not included in this list or having a gain greater than
+3.2dBi are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.
Base Unit : FCC ID: 2AUSA-CC1WRB
Permitted Antennas
•
Linx ANT-2.4-CW-HW, maximum gain of +3.2dBi
•
Linx ANT-2.4-CW-HW-T, maximum gain of +3.2dBi
•
Linx ANT-2.4-CW-HWR-RPS, maximum gain of +3.2dBi
• Linx ANT-2.4-CW-RCS, maximum gain of -0.2dBi
Remote Unit : FCC ID: 2AUSA-CC1WRR
Permitted Antennas
•
Yageo ANTX100P112B24553, maximum gain of +2.2dBi
•
Molex 1461870150, maximum gain of +3.0dBi