Flintec CC1W-30klb, User Manual

Page: 12 / 22

User Manual - CC1W
V1.2 – ISSUED 17 AUG 2020 Page 12 of 22 DOC No. 0095771
4. Operation
1. Disconnect or turn off power to the base unit.
2. Ensure the base antenna connected with RF filter. RF filter always mounted on the
base as shown on pictures.
The remote’s antenna is installed by the manufacturer; to preserve safety
certifications, it is not intended to be removed.
3. Ensure the manufacturer-supplied battery is connected to the remote unit.
4. The remote unit’s indicator LED, if viewable, will flash about twice per second.
5. Connect or turn on power to the base unit.
6. The base and remote will connect on the last-used radio channel in about a
second.
7. If the base unit is set to use an alternate channel, it will switch the load cell to that
channel. This only takes a few seconds.
8. Normal operation begins.
A reconstructed version of the mV/V nominal load cell output will appear at the
base output (for mA variant this is a 4-20mA current loop).
9. As shown on section 4.1 on this manual, if radio interference occurs, an alternate
channel may be selected.
Caution! To preserve safety certifications, do not attempt to remove the remote
from its housing in order to view the LED.