Flex-Pro Norprene A3, Operating Manual

Page: 22 / 39

Page 22
- Dispensing
Input Pump Speed:
Set % pump speed.
Press ENTER to set.
50.0% 0
- Dispensing
Volume to Dispense (mL):
Input milliliters to dispense.
000 1
Press ENTER to set.
9.7 Dispensing
Configure any dispensing amount or sample size and pump will repeat it on
command by pressing START button. Great for accurate single shot dispensing
of a pre-configured volume.
Default settings: 1000 milliliters
50% pump speed
Press SELECT RUN MODE button until Dispensing is displayed in the top line
of the display.
To configure the pump, navigate to Dispensing menu by using short-cut method
described at beginning of section, or by pressing MENU button, then selecting
Input Setup, Input Modes, and then
Dispensing .
Press UP or DOWN arrow to scroll through 0 - 9 on selected digit.
Press RIGHT arrow to scroll over to next digit to right. If you pass your desired
digit, you can easily scroll back by continuously pressing RIGHT button.
Press ENTER to save changes.
Continue this process until all two screens have been configured.
If you used short-cut to enter Dispensing setup, then just press and hold Select
Run Mode button until Run Mode screen is displayed.
If you used Menu button to navigate to Dispensing setup, you must navigate
back out of menu structure. To do this you must select <-Esc at bottom of every
screen menu until you see Run Mode screen displayed.
In Dispensing mode, you can view current
incoming signal count by pressing RIGHT
arrow (see screen shot). RIGHT arrow is a
convenient way to scroll through multiple read-
only screens during normal operating mode of
pump.
Tip!
1500
ML
Dispensing
Å
É
Ä
È
Displays current rotor direction
Flex-Pro