17
8. Ensure the draw switch is connected to one
of the ports at the top center on the back
side of the Jumbo Touch Panel. Then
press/activate the switch. On a system with
two Flavor Burst spouts, check that both
switches are connected to the Jumbo Touch
Panel. Press/activate the one associated
with “spout 1”. A green check mark will
appear, verifying the switch works and is
assigned to spout 1.
9. You can press the BACK button to double-
check your settings and then press FINISH
to exit the Equipment Setup Wizard. Test
your system, especially if the system is
attached to two spouts. Ensure the
switches activate the correct spouts and the
syrup pumps operate with the correct spout
and in conjunction with what is shown on
the Jumbo Touch Panel screen.
10. When the Flavor Burst system is attached to
two spouts, you will see a green button on
some of the screens that says CHANGE
SPOUT. This button gives you access to
the settings for the second spout, in order to
change flavors, clean the cabinet lines and
pumps, etc.
Communications Setup
The Communications Setup section is currently
not important to your basic set up at this time.
The Jumbo Touch Panel is designed to connect
to wifi, and this is the section to check those
connections. Flavor Burst has anticipated
certain wifi features that may be in future
program updates, but they are currently not
available.
If you have an internet browser app installed on
the Jumbo Touch Panel (outside of the Flavor
Burst app), you will be able to access the
internet through the wifi connection.
1. Press the “Password Setup” section in the
Maintenance Menu. Enter the Administrator
Password if prompted.
2. To connect to available wifi or check the
connection, touch “Edit Wifi Connection”
and select from the available wifi providers
on the next screen.
3. You can also test your switch connection(s)
under the Switch Test to make sure they are
working. The active “switch” will turn green.