FLAVIA TD 55 VENETA P5 GR, Use And Handling Instructions

Page: 24 / 36

Operation and installation manual
DISHWASHERS
22
WATER SUPPLY CONNECTIONS
USE ONLY NEW HOSES FOR CONNEC-
TION.
NO REPEATED USE OF USED HOSES
IS PERMITTED. WATER PRESSURE
VALUES SHALL BE WITHIN 0.04 MPA –
1 MPA
Cold water supply connection
Connect the cold water supply hose and
a 3/4" adapter, make sure it is tightened
properly. If the hoses are new, or has not
been used for a long time, let water drain
and make sure it is clean and contains no
impurities. If you happen to ignore this
precaution, the inlet valve may be clogged
which would result in damage to your
dishwasher.
Hot water supply connection
For operation of your dishwasher, hot water
(to be supplied from the central water
supply system) may also be used, unless
its temperature exceeds 60°C. This would
enable to reduce a cycle time by 15 minutes
and slightly deteriorate washing efficiency.
Hot and cold water supply connection
procedures are the same.
ELECTRICAL CONNECTIONS
ATTENTION!
NEVER USE EXTENION CABLES
AND CONNECTING ADAPTERS FOR
THIS APPLIANCE! UNDER NO CIR-
CUMSTANCES DISCONNECT THE
GROUND PLUG FROM THE WIRE
Requirements for electrical
connections
Please, look through the table to contain
power values to find out voltage data and
connect your dishwasher to a power supply
source. Use a 15 A fuse. Use copper wires
only! It is recommended to use a time-delay
fuse and circuit breaker. The socket must be
close to the appliance.
ATTENTION!
Check the earthing before use.
Make sure that the mains voltage value
conforms to that one in the manufacturer’s
plate. Plug in (the socket must be grounded,
too). If the socket doesn’t suit for the plug,
you better replace the socket other than
use any connecting adapters, because
these may overheat and burn.