4.6
REMOVAL / REPLACEMENT OF THE LIGHTBULBS
a)
Isolate the appliance from the electricity supply.
b)
Remove the coal form as shown on page 16, fig 8.
c)
Remove the bulbs from the bayonet fitting and replace with a new one
of the correct specification, as shown below in fig. 14
Fig. 14
PARTS SHORTLIST
Replacement of any other parts must be carried out by a competent person such
as a GAS SAFE registered gas installer or competent electrician.
The part numbers of the user replaceable parts are as follows, these are available
from specialist spares stockists whose details can be found on our web site,
www.cfm-europe.com, in the ‘stockist’ section.
Ceramic Plaques Set
FC-P079648
Gas valve
B-135670
ODS Pilot Assy. (NG)
B-48360
Control Knob
B-137500
Injector
B-63240
Mains Cable
B-77270
Due to our policy of continual improvement and development the exact
accuracy of illustrations and descriptions contained in this book cannot be
guaranteed.
20
Bayonet Fitting
