23
3.3
Removing the Pilot Assembly.
a) Remove the fascia from the front of the fire to a safe location.
b) Unscrew the pilot heat shield.
c) Loosen the pilot pipe and thermocouple then disconnect the ignition lead from the pilot
body.
d) Unscrew the 2 screws that secure the pilot body to the fire.
e) Remove the pilot assembly.
f) Re-assemble with a new pilot and gasket, ensuring that an even seal around the pilot
assembly is obtained.
3.4 Removing the burner from the fire.
a) Remove the fascia from the front of the fire to a safe location.
b) Remove the glass frame as described in section 3.2.
c) Isolate the gas supply.
d) Unscrew the 2 screws that secure the pilot heat shield in place.
e) Unscrew the 2 screws that secure the pilot assembly to the pilot-fixing panel.
f) Remove 11 off fixing screws that hold the pilot-mounting panel in place.
g) Slide the pilot panel upwards and away from the pilot assembly.
h) Loosen the main burner pipe that is situated to L/H/S below the burner on the
bulkhead fitting.
i)
Remove the 2 off fixing screws that secure the burner in place.
j)
Remove the burner from the fire.
k)
Re-assemble in reverse order.
WARNING
If the glass on the appliance is damaged, removed or fitted incorrectly the fire must
not be used
.
