Flatworks plyfly, Assembly Manual

Page: 28 / 79

150718
PL
YFL
Y
rev
A_Steer
spindle
| August 7, 201
5 5:06 PM
1. Press bushings into parts 1‑2, 5‑6, & 7‑8
Note the orientation of part 1 & 2.
Note Be sure to insert the bushing on the opposite side of the alignment mark.
Parts 5 & 6 are left and a right side biased.
Note the location of the bushings.
2. Using a hammer, tap the bushings until the top is flush
with the wooden part.
3. Using a mallet, tap parts 1 into the outer slot on part 5.
4. Using a mallet, tap parts 2 into the outer slot on part 6.
5. Using a mallet, tap parts 3 into the inner slot on part 5.
6. Using a mallet, tap parts 4 into the inner slot on part 6.
Note the location of the bushings. The bushing should face outwards.
Try to ensure 90°
7. Using a mallet, cap the parts 1, 3, 5 with part 7.
8. Using a mallet, cap the parts 2, 4, 6 with part 8.
Note the location of the bushings.
9. Secure the parts using screws on each part.
‒
Use 2 screws on part 5
‒
Use 2 screws on part 6
‒
Use 4 screws on part 7
‒
Use 4 screws on part 8
‒
Total 20 locations, 20 screws.
10. Using a hammer, insert the 5/8” long bolt into each
steering spindle assembly.
Note the location of the bushings
2 1
5 6
7
8
2
6
4
1
5
3
8 7
Assembling the left & right steering spindles
INSTRUCTIONS
24 7 Steering Spindle Assemblies