Flatworks plyfly, Assembly Manual

Page: 48 / 79

150718
PL
YFL
Y
rev
A_GoKart
| Augu
st 7, 20
15 5:0
8 PM
Chapter 10
2
PART
Recommended tools
DESCRIPTION REFERENCE
Dead blow Hammer
or mallet
Allen Wrench
Socket Wrench
Required hardware
№ DESCRIPTION REFERENCE
1 Brake Caliper
PN 12531
1 Short Aluminum Spacer
1/2” OD, 1/4” ID, 7/8” L
PN 12547
1 Long Aluminum Spacer
1/2” OD, 1/4” ID, 1‑1/16” L
PN 12548
2 Oversized Flat Washer
Zinc, M6
PN 12549
2 Socket Head Cap Screw
Black oxide, M6, 55mm L
PN 12550
Part 2 Install the brake caliper
The brakes will initially be installed and then adjusted.
INSTRUCTIONS
1. Insert the socket head cap screws with an oversized flat
washer through the holes located on part 43,
‒
Use 1 socket head cap screw with
1 oversized flat washers per location.
‒
Total 2 locations
2. Insert into the aluminum spacers on the opposite side of
part 43.
Note the location and orientation of the brake caliper. As well as the locations of
the short spacer and the long spacer.
3. Place brake caliper into the cutout located at the rear of
part 43 and insert the hardware.
4. Secure the brake caliper in place, using
the metric Allen wrench provided.
Note the location and orientation of the brake caliper.
43
43
44 10 Putting the go‑kart together