Creator Pro 2 have two independent extruders and support PLA, ABS, HIPS and PVA.
Combination mode:
PVA+PLA
HIPS+ABS
PLA+PLA
ABS+ABS
2.3.7 Material Compatibility
·
·
·
·
·
·
Flashforge materials is the best recommended, even Creator pro2 support open
materials brands. All Flashforge materials have been tested and the best printed
parameters have been used in the FlashPrint.
Thicken the first layer thickness. It is better to adhesion to platform by adding the first
layer filament output.
Set the platform temperature to 30°C, when printed small PLA model or the environ-
ment temperature is higher over 25°C.
Set the platform temperature to 50°C, when printed big PLA model or the environment
temperature is lower over 10°C.
The open printing chamber is good for PLA printing and remove the top cover.
The closed printing chamber is good for ABS printing and close the top cover to avoid
filament cracking.
It is advised to decrease to 40% of standard printing speed. Place PVA filament in a dry
box to avoid printing fails by absorbing water in the air.
PVA filament is water-soluble and has strong water absorption. The filament may soften
after absorbing water, and it is easy to fail printing. Place PVA filament in a dry box when
printing. PVA storage requires sealed and dry storage.
For best results, each material requires different settings.
If you use FlashPrint to slice the model, these settings will be automatically set correctly
when the correct print extruder and material are selected.
Adaptability of materials parameters
Different filament brands have different material characteristics.So it is recommended to
use the expert mode to fine-tune the parameters to ensure a good print quality.
21
